Viper XPT 6000, Руководство пользователя

Страница: 29 / 67

Viper XPT-6000
23
4.3 Starting Spray
To apply the pre-treatment to the shirt, make sure that the shirt is loaded correctly and all the settings are
appropriate, press the green START button. The Viper will pull the platen into the Viper and spray the
shirt.
NOTE: If there is an issue where you need to stop the machine immediately for any reason, press the red
EMERGENCY STOP button at any time. This will stop all motion of the Viper as well as turn all pumps
and solenoids to the off position.
4.4 Unloading and Curing/Drying Garment
Any shirt that has been pre-treated will need to be removed from the Viper and cured or “dried”. The
most common method of curing the pre-treatment is by using a heat press. Check with your
manufacturer’s pre-treatment instructions for the curing / drying of the pre-treatment.
4.5 Pre-Treatment Fluid Laydown Values
The chart in figure 4.5 is a sample representation of the amount of fluid laid down by the Viper XPT.
Though all pre-treatment fluid is going to weigh slightly differently, the chart will get you within general
guidelines. You must refer to the manufacturer’s pre-treatment guidelines for the proper amount of pre-
treatment to be applied to the garments. This may vary from manufacturer to manufacturer for lights and
darks or other types of pre-treatment solutions.