![Viper XPT 6000 Скачать руководство пользователя страница 34](http://html1.mh-extra.com/html/viper/xpt-6000/xpt-6000_user-manual_1029666034.webp)
28
6.
Soak the tips in the small container provided with Image Armor CLEANING SOLUTION so that
the tips are completely submerged.
** NOTE: Sometimes stubborn dried deposits on the tips will cause distortions of the spray pattern.
Soaking the tips in the Image Armor CLEANING SOLUTION overnight and then repeating steps 1-4
above can help remove the deposits and restore clean spray patterns. Thoroughly rinse the tips off
with distilled water to remove any residue of the CLEANING SOLUTION.
5.2.3 - To Clean the Yellow Spray Suppressant Guards:
1.
Remove the guards (fabric) from the inside of the garage door and from behind the spray heads
from the Velcro attachment points.
2.
Rinse under warm water and squeeze to remove pre-treatment build up.
3.
Repeat rinsing until no more pre-treatment is remaining in the suppression guards.
4.
Wring dry.
5.
You can heat press the suppression guards flat and to dry them out. Doing this will result in a
smooth, flat suppression guard to allow for easier installation back into the Viper.
6.
Replace the suppression guards centering them on the provided Velcro strips.
a.
Make sure the suppression fabric behind the spray bars hangs below the elbow (rear point
where the hinge connects) so that it hangs down below that elbow point by about ½”.
b.
Insert the front suppression guard – centering it on the Velcro strip. You can leave this
hang down slightly below the front edge of the throat /opening of the garage door. At
least keep the guard even with the bottom of the front opening on the door to keep build-
up of fluid from happening and resulting in potential drips of fluid on to your garments.
5.3.4 Machine Body Maintenance
To prevent pre-treatment buildup on the Viper, clean the machine’s body
once per day, minimum
. If the
unit is being used heavily and any pre-treatment fluid is building up on the deck or other body
components make sure to wipe these areas down before they get a chance to leak or drain into the
mechanical areas of the Viper.
Items needed:
Image Armor CLEANING SOLUTION
1.
Lift the “garage door” hood of the Viper.
Содержание XPT 6000
