Viega RABS 1250.7US, Руководство по установке

Страница: 55 / 104

55 IM-HC 599871 0321 RABS
Hardware Set-Up Procedures
4.6.1 Resetting the Thermostat to Factory Settings
1 - Button “+”
2 - Button “-”
3 - LEDs
X Disconnect the thermostat from the power supply or remove the
batteries.
X Keep the buttons “+” and “-” pressed simultaneously while
re-establishing the power supply or re-inserting the batteries.
X Release the buttons as soon as the LEDs flash.
Z
The thermostat is in its delivery state again and can be logged in
once more.
4.6.2 Resetting the Control Unit to Factory Settings
Effects of a reset to the functions of the control unit:
„
Interfering data, e.g. resulting from unsuccessful attempts to
establish a radio connection, is deleted.
„
Existing radio connections are disconnected.
„
The assignments of heating circuits, thermostats and range
extenders are deleted and heating profiles are reset to factory
settings.
„
The heating circuits will then be controlled at a constant power level
5 (factory setting).
Proceed as follows to reset the control unit to factory settings:
X Press the unlock button at the right side of the casing and remove
the casing upper part.
The Reset button is located below the button cell lithium battery.
X Keep the Reset button pressed for at least 5 seconds.
Z
The left LED Status in the casing flashes green. The LEDs at the
powerheads emit red light.
X Place the casing upper part on and press it down until it snaps
home.
Z
The control unit is now reset to the factory settings and can be
logged in once more.
After a reset of the control unit, you also need to reset the previously
logged in thermostats.
The company data remains intact when performing a reset.
To change it, go to Central settings menu > Imprint > Support.
1
2
3
RESET