SV Router FC-FC 3 – Installation and User Guide – Sun Release
38
Download Using Ethernet
To download microcode over the Ethernet, you must use FTP.
1. Launch your FTP client, and type
ftp <IP address of SV Router FC-FC 3>
.
2. At the
<username>
prompt, type
vicomftp
.
3. At the
<password>
prompt, type your password, if any.
If the user name and password are correct, an FTP session will open.
4. Type
binary
to set the data format.
Note:
The data format must be set to binary.
5. Type
put <filename>
to upload the file to the SV Router FC-FC 3.
Before the file data is loaded into flash memory, checks are performed to ensure that the
file contains valid microcode in the correct format. When this is completed, the SV Router
FC-FC 3 will reboot.
6. Type
bye
to end the FTP session.
Item 4: View/Change Response to SV Router FC-
FC 3 Management Programs
Item
4
is used to enable/disable access by the SV SAN Builder management software, modify
host worldwide authentication, enable/disable password protection, and modify IP address
authentication (see Figure 3-5).
Changes made here will be written to the SV Router FC-FC 3’s memory only when you press
<Enter>
. If the system has a backup SV Router FC-FC 3, these changes should be duplicated
on that SV Router FC-FC 3 as well.
Содержание FC-FC3
