Building The SAN
11
Configuration of the SV Router includes:
•
Configuring device-side
•
Configuring host-side
•
Enabling Ethernet access
The SV Router’s Ethernet port is in the lower right-hand corner of the rear of the router.
See
Figure 1-2 "Vicom SV Router FC-FC 3 – Rear" on page 3
for Ethernet port location.
By enabling Ethernet access, you will establish a
heartbeat
between the two routers. If one
router dies, the heartbeat will activate failover to the live one. If you did not establish
Ethernet access using RARP, you must do so now through the User Service Utility menu.
To configure the Ethernet settings, you will enter: the IP address, the subnet mask address,
the gateway address, the port number 25000 (default), and if needed, the password to
secure telnet and ftp access.
•
Enter the User Service Utility program and begin configuration
1. Enter 1 to show the SV Router’s
VPD
. The VPD will display the SV Router’s microcode.
•
FC-FC 3 SVE H Firmware Revision : 8.01.03 or later.
2. Enter 9 to Clear the
SAN database
.
•
A successful command will read
“SAN database has been cleared!”
, and
service code 060 will flash.
•
An unsuccessful command will result in service code 051. If this occurs, retry. If the
command continues to fail, replace the router.
Содержание FC-FC3
