Building The SAN
13
Configure Device-Side, Host-Side, and Ethernet
Settings
1. Enter 6 to View and/or Change Interface Configuration
**** WARNING! ****
Upon committing to any changes made from the following menus,
the router will reboot and any active I/Os will be lost.
Continue? (Y/N) Y
2. Enter Y to continue.
3. Enter D to configure the router’s device side.
The SV Router’s FC port are the two lower FC ports on the rear of the SV Router. See
Figure 1-2 "Vicom SV Router FC-FC 3 – Rear" on page 3
to determine device-side port
location. To enable SV Router compatibility with differing devices, the user may change
the device-side FC topology. Here the device-side will be configured for: arbitrated loop
mode, and soft loop ID (soft AL-PA). Both are default settings.
•
Enter R to ensure default settings are entered. Default settings are listed below:
Operating Mode:
Current: Arb Loop mode.
Loop id ==> take soft AL_PA
Default: Arb Loop mode.
Loop id ==> take soft AL_PA
Options:
P = toggle Loop/Point-to-point mode
L = set Loop ID (only if in Loop mode)
? = show settings as changed
R = restore defaults
<Esc> = restore entry settings (discard changes)
<Enter> = accept and exit
Configure which interface?
D = Device Side
H = Host Side
E = Ethernet
<Enter> = doneList default settings
Содержание FC-FC3
