Vicom Systems FC-FC3, Инструкция по установке и эксплуатации

Страница: 44 / 102

SV Router FC-FC 3 – Installation and User Guide – Sun Release
30
User Service Utility Interface Introduction
With the User Service Utility menu, you can: change the configuration of the SV Router FC-
FC 3, setup password protected access to the SAN, download new microcode, and view
information about the SV Router and the storage subsystem.
You can use either the serial port or the Ethernet port to reach the User Service Utility. Before
making your choice, please note the following:
•
You can assign or change the IP Address of the SV Router via serial port access or by
RARP. See ‘Configuring the IP Address’ on page 33 for more information on RARP
usage.
• The IP Address is required to telnet to the SV Router; without it, you cannot connect.
• If you change the IP Address of the SV Router while you are communicating via
telnet, the connection will be dropped.
•
You cannot download microcode to the SV Router using telnet; you must use FTP.
•
You can assign two passwords for controlling access to the SV Router. These passwords
are unrelated and can be different.
• In Item 4: View/Change Response to SV Router FC-FC 3 Management Programs , you
can assign a 20-character password to restrict clients running SV SAN Builder from
accessing the SV Router (either in-band or out-of-band).
• In Item 6: View/Change Interface Configuration , you can assign a 10-character
password to restrict Ethernet access to the User Service Utility menu. Without this
password, you cannot telnet to the SV Router.
•
Serial Port requirements:
• Windows NT/2000, or Windows 98/95.
• Serial Port cable – DB9 (female to female).
• Communications software (PROCOMM PLUS® 3.0 or Windows HyperTerminal).
•
Ethernet Port requirements:
• Ethernet cable – RJ-45.
• Telnet.
• FTP.