Vicom Systems FC-FC3, Инструкция по установке и эксплуатации

Страница: 60 / 102

SV Router FC-FC 3 – Installation and User Guide – Sun Release
46
•
M
: Select
M
to change the subnet mask value, which defines the extent of the network in
which the SV Router FC-FC 3 will be operating. Type the subnet mask, then press
<Enter>
to change. The default value is
255.255.255.0
.
•
G
: Select
G
to change the default gateway value, which is necessary when establishing a
line of communications between nodes in a multiple-network environment. Type the
default gateway, then press
<Enter>
to change. The default value is
0.0.0.0
.
•
N
: Select
N
to change the SV Router management server port number. This defines the port
through which the SVE Daemon establishes communications between the SV Router FC-
FC 3 and a client running one of the SVE applications. Type the new port number, then
press
<Enter>
to change. The default value is 25000.
Note: If the server port number is changed from 25000, it must be reflected in the SVE Daemon
configuration file (see the
SV SAN Builder – Installation and User Guide
for more
information).
•
P
: Select
P
to create a new 10-character password or modify the existing password. This
password applies to telnet or FTP client sessions only. Disable password protection by
pressing
<Enter>
as the first character.
Item 9: Clear SAN Database
Select item
9
to clear the SAN Database.
Clearing the SAN Database will erase all drive configuration information. It is recommended
that you make a backup before you clear the SAN Database.
Figure 3-13
Clear SAN Database command response
•
A successful command will read
“SAN database has been cleared!”
, and service
code 060 will flash.
•
An unsuccessful command will result in service code 051.
After you clear the SAN Database, power cycle the SV Router.