Vertical WAVE IP 2500, Руководство по установке

Страница: 66 / 236

About the Wave IP 2500 Server 4
-
4
Chapter 4: Setting Up the Wave IP 2500 Server
Wave Server Installation Guide
Power supply
The Wave IP 2500 Server is equipped with one power supply.
If a power failure occurs, an optional Uninterruptable Power Supply (UPS) can provide several
minutes of system power, allowing the Wave Server to be properly shut.
A UPS is not provided by Vertical Communications, but can be purchased from a third-party
source. For information about recommended UPS specifications, refer to Appendix C in the
Wave Server Hardware Reference Guide .
Wave IP 2500 Server expansion options
The ISC1 is the minimum requirement for a Wave IP 2500 system.
There are several ways to expand the Wave IP 2500 Server base unit to handle additional users
and increased traffic, and support a wide variety of trunk and station configurations:
• Expansion cards and modules
• Expansion Units (EXUs)
• Media Resource Modules (MRMs)
For technical specifications for these expansion components, see the Wave Server Hardware
Reference Guide .
Expansion cards and modules
The Wave IP 2500 Server supports two kinds of expansion boards—modules and cards.
•
Modules
are partial-width boards that can be installed in module slots in the base unit or
in Expansion Units (EXUs, described on page 4-5).
Modules can also be installed in universal card slots in the base unit or in EXUs using the
IP 2500 Module Conversion Kit (VW-IP2500-CONV), a mechanical assembly which
attaches to a module.
The following modules are available:
•
Analog trunk module.
Supports 8 analog FXO loop start or ground start trunk ports.
See page 4-23.
•
Analog universal module.
Supports 8 analog FXS station ports and 8 analog FXO
loop start or ground start trunk ports. See page 4-24.
Release 4.0 June 20, 2013