Vertical WAVE IP 2500, Руководство по установке

Страница: 226 / 236

Troubleshooting ViewPoint problems F
-
8
Appendix F: Troubleshooting
Wave Server Installation Guide
Troubleshooting ViewPoint problems
Firewall problems may prevent ViewPoint from starting.
Symptom: After installing ViewPoint successfully on a PC, the following message is displayed
and ViewPoint fails to start:
“Wave Server is unable to connect to ViewPoint, which could be due to a configuration
issue on the Wave Server. Please contact your administrator so the can check if the Wave
Global Administrator's Workstation Firewall settings allow connections from
nnn.nnn.nnn.nnn”
where “nnn.nnn.nnn.nnn” is the IP address of the Wave Server.
This problem may occur if your company network is defined as a “public network” on the PC’s
network settings and there is a firewall between the PC and the Wave Server. Additionally,
internet security programs such as McAfee may prevent the connection.
Solution: Define the network to the Wave system as a “work network” instead of a “public
network” to eliminate the firewall between the PC and the Wave Server, or allow access by the
Wave Server through the PC’s firewall.
On a system configured with a locale of “Spanish (Spain)”, a long distance prefix may
be incorrectly added before dialing a long distance number via ViewPoint.
Symptom: A “0” prefix may be incorrectly added before dialing a long distance number via
ViewPoint, even though long distance prefixes are not used in Spain.
This problem has been fixed on new systems as of Wave ISM 1.5 SP3. However, if a system
was previously configured to use the “Spanish (Spain)” locale it is possible that ViewPoint may
still incorrectly add a “0” before dialing a long distance number.
Solution:
1. Start the General Settings applet.
2. On the System tab, click
Apply
. (The
Apply
button will be enabled even though you have
not yet made any changes.)
3. Click
Done
.
Release 4.0 June 20, 2013