SIP Configuration, General Parameters
3-23
Chapter 3: Using the LCD Configuration Menu
Edge 5000 Installation / Configuration Guide
Backup Proxy Port
The Backup Proxy Port defines the port used when sending SIP messages to the backup proxy
defined under
“Backup Proxy Address” on page 3-22
.
To assign the Backup Proxy Port:
•
Press the Settings (
) button. If the LCD Menu is locked, use the unlock
procedure. Refer to
page 3-4
.
•
Press the
digit, or move the cursor to 2.SIP Configuration using the
[Next]-[Previous] softkeys and press the [OK] softkey.
•
Press the
digit, or move the cursor to 5.Backup Proxy Port using the
Next]-[Previous] softkeys and press the [OK] softkey.
•
Input the Backup Proxy Port using the dial pad and press the [OK] softkey to save
your entry.
•
Move to another parameter with the navigation buttons and continue the session or
press the Settings (
) button to exit the configuration session.
NOTE
:
Changing the Backup Proxy Port requires a reboot of the IP Phone; when you leave the menu,
you will receive a reboot notice. The IP Phone must reboot to utilize the new values entered.
Local UDP Port
The Local UDP Port defines the port, normally 5060, the IP Phone uses to send and receive
SIP signaling packets. In some instances, particularly when behind a firewall, the normal port
may not be available. If port 5060 is not available, a different port can be defined.
To set the Local UDP Port:
•
Press the Settings (
) button. If the LCD Menu is locked, use the unlock
procedure. Refer to
page 3-4
.
•
Press the
digit, or move the cursor to 2.SIP Configuration using the
[Next]-[Previous] softkeys and press the [OK] softkey.
•
Press the
digit, or move the cursor to 6.Local UDP Port using the
[Next]-[Previous] softkeys and press the [OK] softkey.
•
Input the Local UDP Port using the dial pad and press the [OK] softkey to save your
entry.
•
Move to another parameter with the navigation buttons and continue the session or
press the Settings (
) button to exit the configuration session.
NOTE
:
Changing the Local UDP Port requires a reboot of the IP Phone; when you leave the menu, you
will receive a reboot notice. The IP Phone must reboot to utilize the new values entered.
Release 1.0
September 2010
Содержание Edge 5000
