Wall Mounting
2-6
Chapter 2: Installing the IP Phone
Edge 5000 Installation / Configuration Guide
Wall Mounting
The IP5000 series phones incorporate wall mounting in the base of the phone housing. Using
the instructions below and the illustration, wall mount the IP-5000 phone.
•
Mark and drill two 7 mm holes for plastic wall anchors with a vertical separation of 10
cm.
•
Insert two (2) anchors into the holes, then insert and tighten the two (2) screws leaving
about 2.5 mm exposed. Refer to the figure below.
•
Attach all wiring to the IP Phone as described in "Connecting the IP Phone" starting on
page
2-1
.
•
Slide the IP Phone over the screws and assure the phone is secure. Note it may be
necessary to remove the phone and tighten or loosen the screws for a secure
mounting. Also note, the Foot Stand must not be attached to the IP Phone when wall
mounting.
•
Remove the Handset hook from the phone as shown in the figure below. Reverse the
hook and re-install in the IP Phone so that the hook catches the groove in the handset
receiver.
•
Complete all wiring as described in "Connecting the IP Phone" starting on page
2-1
.
Release 1.0
September 2010
Содержание Edge 5000
