Vertical Edge 5000, Инструкции по установке/настройке

Страница: 129 / 168

Edge 5000 Installation / Configuration Guide
Appendix D
Using the Configuration File
Configuration Parameters
During automated provisioning with the Config. Download flag, see
“Upgrade Configuration” on
page 4-29
enabled, IP Phones attempt to download a global and a phone specific configuration
file from a TFTP or Web server supporting HTTP/HTTPS. The global file
"sysconf_5000_sip.cfg", is typically for parameters with the same value for all IP Phones
connecting to the server. Parameters such as Network mode, Provisioning, Daylight savings
time mode are typical globally settings.
• The phone-specific configuration file as a default uses the MAC address of the phone for
the file name, for example 00405a123477. When using HTTP/S, the IP Phone can be
assigned with a name for the phone specific file in place of the MAC address but the MAC
address must be included in the file name or path. Parameters specified in the phone
specific configuration file override those defined in the global configuration file.
• Both the global and MAC configuration files can configure any of the parameters of the IP
Phone; the only difference is the MAC file values have priority over the global file. Each is
an ASCII file with parameters (fields) grouped under the various sections of the
configuration file, see "Configuration Parameters" starting on the next page. By assigning
values after the field name, the IP Phone configuration parameters are established.
• A field listed in the configuration file with no value will return the value of the associated
parameter to default. If a value is changed for a field marked with an asterisk in the
“Configuration Parameters”
table (starting on page D-2), the reboot flag will be enabled and
the IP Phone will reboot after initialization is complete. The first line of the configuration
file (global or phone specific) must be "IP5000 configuration information (v1.0)" as shown
in "Sample Configuration File" on
page D-22
.
• The IP Phone supports SSL and allows assignment of a user name and password to
authorize access to the HTTPS files. In addition, using HTTP/HTTPS the configuration
files can be encrypted using a 32-byte key, which must be assigned to the phone or
passed via the configuration file; the phone will use the 3DES algorithm to decrypt the file.
• In DHCP mode, the values from the DHCP server have a higher priority than the values in
the sysconf_88xx_sip.cfg and phone-specific configuration files.
• The table below shows the configuration parameters by Section and Field name along
with descriptive information. The 2nd table on
page D-29
shows selections available for
the time zones. The illustration on
page D-22
provides a blank configuration file. List a field
in the configuration file only if the field requires an assignment other than default. If a field
is erased or commented-out, it will have no affect on the IP Phone memory; the phone will
use the existing value in memory. Deleting an unused field line from the configuration file
also reduces traffic between the provisioning server and the IP Phone during a boot cycle.
Release 1.0 September 2010