VeEX MTX150 Series, Руководство пользователя

Страница: 137 / 303

137 © VeEX Inc. All Rights Reserved. Ethernet
The selected tests will run automatically. When all the tests are complete the test will stop automatically. If the
Throughput test suite needs to be stopped before they are done, then simply press the
Stop button, located in
the actions drop-down menu. The status of each selected test can be seen in the Results tab.
l
Far-End Unit Controlled with Loop Up/Down Commands
l
If the far-end unit is not manually looped back, then it must first receive a loop up command
from the control unit before the Throughput test suite can be started.
l
To loop up the far-end unit with the manual mode loop up/down commands, configure the con-
trol settings mode to manual.
l
Enter the MAC and/or IP address of the far-end unit.
l
Send the loop up command by tapping on the Loop Control button and pressing Loop Up .
Once the far-end unit has been looped back, start the test by pressing the Start button. When the all of the
selected test are completed, the Throughput test suite will stop automatically. Once all tests have been com-
pleted and there is no need to test again, go back to the Control tab, and press the
Loop Down button. This will
send a loop down command to the far-end unit to remove the loopback that is in place.
Throughput Results
Viewing Throughput (Multiple Streams) Test Results
When the test is first started, the screen automatically changes to the Global/Aggregate results screen.
Global/Aggregate Results
The Global results pages displays measurements for all traffic streams as well as non test traffic.
The Stream Summary screen displays:
l
Stream number (#)
l
Total received bandwidth per stream
l
Errors/alarms associated with the stream
l
Quality of Service (QoS) performance verification associated with each stream