Vatech A9 (PHT-30CSS)
Technical manual
VDH-TeM-098
195 / 214
COPYRIGHT© 2020 VATECH
.
ALL RIGHTS RESERVED
Command
Remark
[SPM_FO?_]
Requesting the image rotator start position offset value in
FAST PANO mode
[SPM_CFRQ_0000]
Setting CEPH Sensor Supply Frequency (Normal Scan)
[SPM_CFR?]
Request CEPH sensor supply frequency value (Normal
Scan)
[SPM_CCTM_0000]
Setting CEPH Total Recording Time (Normal Scan)
[SPM_CCT?]
Requesting CEPH Total Recording Time Value (Normal
Scan)
[SPM_CAST_xxxxx]
Setting Position value for 1-axis Collimator (Left/Right)
(CEPH)
[SPM_CAS?]
Calling CAST Stored Values
[SPM_CBST_xxxxx]
Setting Position value for 1-axis Collimator (Left/Right) (Cu +
Al filter)
[SPM_CBS?]
Calling CBST Stored Values
[SPM_CCST_xxxxx]
PANO mode collimator reference position setting command
[SPM_CCS?]
Call CCST Stored Value
[SPM_CDST_xxxxx]
Position value setting for 1-axis Collimator (Left/Right) Cu
filter
[SPM_CDS?]
Call CDST Stored Value
[SPM_CEST_xxxxx]
Position value setting for 1-axis Collimator (Left/Right) Al filter
[SPM_CES?]
Call CEST Stored Value
[SPM_CFST_xxxxx]
CT mode collimator reference position setting command
[SPM_CFS?]
Call CFST Stored Value
[SPM_CSCN_xxxxx]
CEPH scan distance
[SPM_CSC?]
Request CEPH scan distance value
[SPM_XRFA_xxxx]
Set the CEPH sensor side reference position
[SPM_XFA?]
Request the CEPH sensor side reference position value
[SMP_END__0000]
Notifies to PC that the exposure switch is no longer pressed,
and It came to the lamp position (End after normal captured)
[SMP_STOP_0000]
Notifies to PC that the exposure switch is no longer pressed
(Ended after abnormal captured)
[SMP_STAR_0000]
Notifies PC to start capture
[SMP_LOF__0000]
Notifies the PC that the laser is off.
[SMP_LON__0000]
Notifies the PC that the PANO mode laser is on.
[SMP_PKEN_0000]
Notifies the PC that it is booted in Packing mode. (Notified in
response to [SPM_ISPK] or [SLM_ISPK] commands)
[SMP_DROP_0000]
Notifies the PC that the door lock function is in use (notified
in response to [SPM_ISDR] command)
[SMP_DCHK_0002]
Message sent before the [SMP_STOP_0000] command is
sent at the end of abnormal capture because the door is
opened.
