Van Der Stahl FAS-402-CH Series, Руководство по эксплуатации

Страница: 32 / 68

32
FAS-402-CH/ FAS-602-CH Series Operating Instructions Ver. 1.05E
[ 0 x ] Change Move
VT x x . x sec
HT xx
O
C x . x s CT xx
O
C
( The cursor flashes )
[ 0 x ] Change Move
VT x x . x sec
HT xx
O
F x . x s CT xx
O
F
( The cursor flashes )
[ 01 ] SEALING ONLY
Change(number)
Change(item)
COUNTER xxxxx TEMP
[ 0 x ] METHOD Select
1 SEAL 2 VAC&SEAL
[ 0 x ] VAC TYPE Select
VAC&SEAL
1 Manu 2 Time 3 Gauge
( The cursor flashes )
MENU / / MENU=Back
1 Entry 2 Change
3 Delete 4 Maintain
“VT” stands for the vacuum time. Adjust the vacuum
time using the
/ buttons.
[Setting range : 0.1 ~ 99.9seconds]
2 Ŷ
Enter(register) a new operation pattern:
Place the cursor to "1 Entry" by pushing the
/ buttons. Skip to the procedure 3 .
3 Press the button. The below display will
be shown on the screen.
Select the either one of 1Manual, 2Time,
3Gauge using the / buttons. Press the
button to confirm the setting.
If you hold the button in, the numeric value will
increase/decrease continuously. Use this method
when making wide range changes in the settings.
[Setting range: 40
O
C/ 100
O
F ~ set heating
temp]
The below menu display will be shown.
Ŷ
Change the registered operation
pattern:
Place the cursor on "2 Change" using /
buttons. Push button.
Select the desired number you would like to
change using the
/ buttons and push
to select.
4 Place a cursor to “2 VAC&SEAL” using the
/ buttons. Press the button. The
below display will be shown on the screen.
8-4-8 Select the vacuum pattern
1 Push button when the display shows
one of the registered operation pattern as
below example.
(e.g. [01] SEALING ONLY)
8-4-9 Set the vacuum time
Refer to "8-4-8 Select the vacuum pattern” and select
“2 Time”.
Place the cursor to "2 Time" and push
button.
The following display will be shown on the screen.
Attention
If the extreme setting is going to be
made, the following warning is
displayed on the screen for 4
seconds.
TIPS
If cooling temperature is set
extremely high, strong and beautiful
seal cannot be made. Please allow
sufficient cooling depending on each
film.