Valco Cincinnati VC350A, Руководство пользователя

Страница: 33 / 327

Section 6 — Installation
VC350A Flexoseal ® System
Valco Cincinnati 6-16
Figure 6-15. Channel II Board
Glue Valve Installation for a Two-Channel System
To install one glue valve for pattern-skip-pattern (P-S-P), follow these steps:
1. Connect glue-valve cable to “J3-Valve 1” (see Tables 6, 7, and 8 for connections).
2. Set JP1 on the main board (Figure 6-14) to the SC1 position.
3. Set SW7 on the channel II board (Figure 6-16) to the P-S-P position (down).
Note! SW6 can be set to either position. The “Gun 1” selector switch on both channels will operate P-S-P.
The “Gun 2” selector switches will not be operational and should be disconnected.
To install two glue valves dispensing different patterns, follow these steps:
Note! Gun 1, channel 1 = valve 1. Gun 2, channel II = valve 2. Gun 2, channel 1 and gun 1,
channel II are not operational and should be disconnected.
1. Connect glue valve cables to “J3-Valve 1” and “J4-Valve 2” (see Tables 6, 7, and 8 for connections).
2. Set JP1 on the main board to the SC1 position. If two scanners are used, set JP1 to the “SC2” position
(scanner 1 controls channel 1, scanner 2 controls channel II).
3. Set SW6 on the channel II board to the P-S-P position (down).
4. Set SW7 on the channel II board to the CH2 position (up).
To install four glue valves dispensing two different patterns, follow these steps:
1. Connect glue valve cables 1 and 2 to J3-Valve 1” and “J4-Valve 2” of the lower valve-driver board (see
Tables 6, 7, and 8 for connections).
2. Connect glue valve cables 3 and 4 to J3-Valve 1” and “J4-Valve 2” of the upper valve-driver board.
3. Set JP1 on the main board to the SC1 position. If two scanners are used, set JP1 to the “SC2” position
(scanner 1 controls channel 1, scanner 2 controls channel II).
4. Set SW6 on the channel II board to the CH2 position (up).
5. Set SW7 on the channel II board to the CH2 position (up).
SW6
SW7