Vaderstad Rapid RDA 400S, Инструкция по эксплуатации

Страница: 65 / 110

RDA 400-450 S
Ver.3 29.06.2007 65
3.2 Checking the seed feed
Figure 3.2
The seed feed should be checked at the same time as the sowing depth, i.e. after every 4 hectares
or once an hour.
In connection with output verification, check that the machine appear to be outputing the same
amount from each coulter.
Hydraulic output:
Raise the machine. Start the fan. Operate seed output for a short while by depressing the button
on the Control Station. Check whether seed is output.
Start from the tramlining position, when all boxes, except those shut for tramlining, are supposed
to output seed. Then advance the tramlining function and check to see if these coulters deliver seed
now.
Mechanical output:
Raise the machine. Rotate the drive wheel by hand one full revolution with the fan not operating
(for safety reasons). Then start the fan and check whether seed is output. Repeat the procedure if
there is any doubt about seed output from the machine.
Start from the tramlining position, when all boxes, except those shut for tramlining, are supposed
to output seed. Then advance the tramlining function and check to see if these coulters deliver seed
now.
This sowing system has been developed to deliver even seed feed and reliable sowing rates.
Väderstad-Verken AB shall not be held liable for any claims for indirect or consequential damages
relating to losses incurred in connection with the use of the drill. In addition Väderstad-Verken
AB accepts no liability for losses arising from incorrect use of the sowing or seed feed functions
of the drill or any part thereof.
It is the responsibility of the operator to use properly pre-treated seed, treated with dressings which
do not impair or prevent seed feed. Note that the use of seed types larger than normal pea seed can
block the seed feed system.
Filling the seed hopper
Please study the section ”
2.17 Prior to filling the hopper” on page 35
before filling the seed hop-
per.