☞
If the Method is setup as
Serial,
a separate
Serial
setup is needed.
-
If the Method is setup as Serial, press
[Next]
button then Serial setup
screen for remote control button comes out.
- Serial data can be input as byte unit and it is available up to 32 byte.
- Select the data value from 16 digit button (from 0 to 9 and from A to F) and
press
[Input]
button to save the data in a result window.
- Press
[Baudrate]
button to setup Baudrate in the Remote Control / Device
button your wish to use.
- Press
[Parity]
button to setup Parity in the Remote Control / Device button
your wish to use.
- If you want to cancel the input result, press
[Reset]
button and try again.
- Press
[Next]
,
Serial
setup is completed.
- Basic Serial communication setup is as follows.
[ Stop bit : 1bit / Data bit : 8bits / No flow control ]
⑤
Port
: Setup an individual number for each Port of RF receiver to
control the device you wish to operate.
⑥
Function
: Select a method of signal output from
[Trigger]
,
[High]
,
and
[Low]
only when the
[Method]
button is setup as
[Relay]
.
⑦
Delay
: You can setup Trigger time only when the
[Function]
button
is setup as
[Trigger]
.
You can setup the time range from 1ms to 1s (1000ms).
6
IR/RF setting is completed.
To continue setting IR/RF, press
[Yes],
or press
[No]
to finish.
Note
.
Once setup, you don‟t need to change any functions unless a problem
occurs.
53
