APPENDIX B
-
SP2100 2D Imager Setup Barccodes, con’t
BarcodeGuy.com® - UnionNet SP2100 User’s Guide
2D
Im
ag
er
O
nly
Programming “ON”
Programming “OFF”
Figure B.0
Instructions:
To change the option, first scan the
Programming “ON”
barcode.
Then scan the Option Code. Finally scan the
Programming “OFF”
barcode.
30
B.8 - Interleaved 2 of 5 ( I2of5 ), con’t
I2of5 - Check Digit
Don’t Transmit
I2of5 - Transmit
Check Digit
I2of5
No Check Digit
Set I2of5
Min Code Length
(Default = 6)
Set I2of5
Max Code Length
(Default = 82)
NOTES:
* String length must be less than 127 bytes.
* MAX LENGTH must be less than or equal to MIN LENGTH.
* If MIN LENGTH = MAXLENGTH, only that single length barcode
string will be allowed.
5.
Scan the
Save Programming
barcode, then scan the
Programming “OFF”
barcode.
Interleaved 2 of 5 may include a Check Digit (not compulsory) as the last digit of the encoded string. When used, the check digit is the
result of the symbology's mathematical check of the preceding digits. Below are the options:
●
No Check Digit
-
Read without performing the check using the last digit and transmit all digits. In effect, there is no check digit
present.
●
Transmit Check Digit
-
The last digit is a check digit. Perform the mathematical check using the last digit as validation. Transmit
the check digit as part of the string to the host.
●
Check Digit Don’t Transmit
-
The last digit is a check digit. Perform the mathematical check using the last digit as validation, but
don't transmit the check digit to the host.
Specified Lengths
- To limit the length of the barcode string as a form of validation, you can set a a specifid length in accordance
with the following rules:
●
Scan the Specified Length as a 3 digit number; ie: a length of 12 would be scanned as
0 1 2
.
●
The Specified Length value must be an even number between 2 and 24.
Exmple:
Only allow barcodes to be scanned that are 12 or 24 digits long:
1.
Scan the
Programming “ON”
barcode.
2.
Scan the
Enable Specified Length
, then scan the
Add Length Code barcode
.
3.
Scan the 3 digit representation of the length desired from
Section B.29
of this Appendix (B) in this case
0 1 2.
4.
Scan the 3 digit representation of the length desired from
Section B.29
of this Appendix (B). in this case
0 2 4.
I2of5 - - Enable
Specified Length
I2of5 - Disable
Specified Length
I2of5 - Remove
Length Code
I2of5
Add Length Code
Содержание SP2100
Страница 64: ...64 BarcodeGuy com UnionNet SP2100 User s Guide APPENDIX E Android UniLinker and SP2100 in SPP Mode ...
Страница 69: ...69 BarcodeGuy com UnionNet SP2100 User s Guide APPENDIX G SP21001D Scan Engine Symbology Default ...
Страница 71: ...71 BarcodeGuy com UnionNet SP2100 User s Guide APPENDIX I SP21001D Scan Distance Chart ...
