Fig. 5.50
Fig. 5.51
Fig. 5.52
Fig. 5.53
l
Take out head lamp bulb by snapping out the
clip (A) and replace with a new one. (Fig 5.50)
Head lamp bulb
12V, 60/55W H4
l
Reassemble the parts in the reverse order of
removal.
Note:
After reassembling head lamp, readjust
the head lamp beam as explained in
chapter “Periodic maintenanc
e” page
2-38)
Do not touch the halogen bulb at it will
reduces its life and performance.
POSITION LAMPS - REPLACEMENT
l
Remove the housing head lamp mounting
bolts and tilt the housing head lamp as
explained in the pervious page.
l
Remove the hexagonal nuts (M6 - 4 nos.)
from the bracket housing head lamp along with
the punched washer. (Fig. 5.51)
10 mm spanner
Tightening torque
3 ± 1 Nm
l
Remove the CRR pan head tap screw (M6x16 -
2 nos.) from the bracket housing head lamp.
(Fig. 5.52)
Phillips head screw driver
Tightening torque
1.5 ± 0.5 Nm
l
Gently pull out the turn signal lamp by
dislocating it from the lugs and separate the
housing head lamp front and rear.
l
Disconnect the position lamp assembly
connector. (Fig. 5.53)
TVS APACHE RTR 200
SERVICE MANUAL
ELECTRICAL SYSTEM
5-21
A
