www.Turtle-Beach.com
Page 16
To connect AudioTron to an HPNA Network…
1.
On the AudioTron rear panel, locate the HPNA interface with two RJ-11 modular phone jacks labeled
PHONE
and
LINE
. The jack labeled
LINE
is for connection to the HPNA network, while the jack labeled
PHONE
is a 'pass-through' for connection to a telephone or answering machine.
2.
Insert the phone cable (included with your AudioTron) into the LINE connector. Insert the other end into
your phone jack.
3.
If you had a phone connected to the phone jack, you can insert the phone line into the connector labeled
PHONE. This allows you to connect both AudioTron and a telephone to a single phone jack on the wall of
the room where you listen to your AudioTron.
4.
Proceed to the section called “Configuring AudioTron’s Network Settings”.
Figure 8
Connect the AudioTron LINE jack to the HPNA network using the supplied RJ-11 phone cable.
Stereo
System
Analog Phone Line
C
AudioTron
HPNA Connection
PC with
HPNA interface
Phone
PC with
HPNA interface
Phone
Wire
RCA or
Optical
audio cable
Phone
Plug
Phone
Wire
Phone
Wire
Phone
Wire
Phone
Plug
Phone
Plug
Phone
Plug
Figure 9
In a multi-PC HPNA network, each device in the network can be connected directly to the phone line.
The normal operation of your telephone is not interrupted by the network activity.
