Tseng Qtec VGA 1024, Руководство по установке

Страница: 41 / 123

in the CONFIG.SYS file on a bootable disk, and place EANSI.SYS and
BASICA.COM on that disk. Boot the system, and in response to the
DOS prompt, type BASICAr then press ENTER and type the following
BASIC commands:
OPEN "0",1,"TEMP.DAT"
PRINT #1, CHR$(27);"[=34h";
CLOSE
SYSTEM
This creates the file TEMP.DAT, containing the escape sequence to
select mode 22 hex, 132-column mode. In response to the DOS
prompt, type
TYPE TEMP.DAT then press ENTER
which sends the escape sequence to the screen. The screen is
immediately set to 132-column mode. Note that the escape sequence
is not displayed; it is interpreted as a command rather than
displayable text.
-30-