Tseng Qtec VGA 1024, Руководство по установке

Страница: 40 / 123

USING THE REPLACEMENT ANSI STANDARD CONSOLE DRIVER
Format: DEVICE=EANSI.SYS
This command must appear in the configuration file (CONFIG
t
S Y S ) . to
install EANSI.SYS, just as the command to install the ANSI.SYS
device driver that comes on the DOS diskette would appear.
EANSI.SYS is compatible with the standard ANSI.SYS, and
additionally supports the extended screen modes provided by Qtec
VGA1024. Once installed with the above command, EANSI.SYS
provides all the screen control and keyboard remapping features of
ANSI.SYS (see your DOS Technical Reference manual). EANSI.SYS is
a replacement for ANSI.SYS, and the two should not be in use at
the same time.
EANSI.SYS may be used to select the extended Qtec VGA1024 screen
modes. This is accomplished by issuing an escape sequence with
the "set mode" command, just as any standard mode would be
selected with the normal ANSI.SYS. For example, screen mode 22
hex would be selected by sending the escape sequence:
(Esc)[=34h
to the screen. (Note that 34 is the decimal equivalent of 22
hexadecimal). To select other modes, simply replace 34 with the
number of the mode you wish to select.
The available extended screen modes using an enhanced color
display are as follows:
Mode
Columns Rows
34 dec (22 hex)
132
44
35 dec (23 hex) 132 25
36 dec (24 hex) 132 28
42 dec (2A hexi 100 40
38 dec (26 hex)
80
60
2 dec (02 hexj
80
25
For example, to place the screen in 132-column by 44-row mode, do
the following. Place the DEVICE command:
DEVICE=EANSI.SYS
-29-