Tseng Qtec VGA 1024, Руководство по установке

Страница: 31 / 123

15. Now, identify levers 5 and 6 on switch block 1. Identify them
by the numbers imprinted along one edge of the switch.
16. Using the tip of a ballpoint pen or similar object, set levers
5 and 6 on switch block 1 to the QN position. The ON and OFF
positions are usually marked along the side of the switch.
17. Hold the computer cover as shown in the figure below, with its
front facing you, tilting down in the back. Slip the upper
rear edge of the cover over the top of the computer front
panel.
18. Lower the cover and carefully slide it back over the
computer. Be sure that the lips along the bottom of the cover
slide along the rails on each side of the computer chassis.
19. Install the five mounting screws (reverse of Step 5) that hold
the cover to the computer.
20. You are now ready to reconnect all cables (reverse of Step 3)
to the rear of the computer. If necessary, refer to the
instructions supplied with your display monitor, printer or
other equipment.
21. After you reconnect all the cables, refer to the documentation
provided with the computer to learn how to turn on and use
your computer.
-22-