Tseng Qtec VGA 1024, Руководство по установке

Страница: 64 / 123

DRIVERS INSTALLATION
FOR GEM 2.2-3.1
The GEM drivers on your Qtec VGA1024 driver diskette are used
for GEM versions 2.2 and 3.0-3.1. The drivers whose file
extensions end in .VGA are for GEM Versions 3.0-3.1, while
those ending in .SYS are for GEM Version 2.2. This is
transparent to the individual GEM programs as they will seek
out the appropriate driver files during loading.
Please note that the Qtec VGA1024 Driver Diskette supplied to
you is created specifically for the drivers contained
therein. The original has a volume label called GEM DRIVRPK
that GEM must see in order to load the drivers. If you need
additional back up copy of your driver diskette, it must be
indentically copied using the DOS DISKCOPY command in order to
preserve the integrity of the order and content of the
original.
Driver Installation for GEM 2.2
The following instructions are applicable to users of GEM Version
2.2 and the Qtec VGA1024 Adapter.
Please be sure that your monitor is capable of displaying these
resolutions in order the utilize the drivers. Choosing a higher
resolution than your monitor is capable of displaying will bring
unsatisfactory results.
The enclosed GEM driver files require a new GEMSETUP.TXT file to
be installed in place of that which is on GEM Device Driver
Diskette #1. The driver makes full use of the 800x600 and
1024x768 graphics mode of the Qtec VGA1024 adapter.
Before installing GEM, perform the following steps:
1. Make a DISKCOPY of GEM Device Driver Disk #1. This copy will
be used in place of the original during installation.
2. Copy GEMSETUP.V22 from your Qtec VGA1024 Driver Diskette to
the newly-created copy of the GEM Device Driver Disk #1, as
GEMSETUP.TXT.
-50-