7.
Carefully
slide the computer cover towards you.
When the
cover will
not go any further, tilt it upward and gently lift
it away from the computer.
8.
Look at the Qtec VGA1024 board and locate the switch block.
9.
To
set the switches on your Qtec VGA1024 board, refer to the
Guide to Switch Settings on the following pages.
You need to set the switches to indicate:
* The type of display monitor attached to your Qtec VGA1024
board.
* The mode of operation desired on system power-up (i.e.,
VGA, EGA, CGA, MDA).
* Which display the computer should use, if more than one
display is attached, when the power is turned on.
The Qtec VGA1024 provides two video connectors, the 15-pin
(DB15)
analog
connector
and 9-pin
(DB9)
TTL
(digital)
connector.
The
15-pin
(DB15)
connector is for interfacing
Qtec VGA1024 with analog monitors such as IBM PS/2 monitor
(IBM 85xx)
or variable-frequency monitor (analog mode).
The
9-pin
(DB9)
connector is
for interfacing with TTL (digital)
monitors only.
-7-
Содержание Qtec VGA 1024
