Trinity Highway QuadGuard Elite M10, Руководство по сборке изделия

Страница: 18 / 60

TrinityHighway.com 17 Revision C September 2021
Hammers

Sledgehammer

Standard hammer
Wrenches

Heavy duty impact wrench

Standard adjustable wrench

1/2" drive Sockets: 9/16", 11/16", 3/4", 15/16", 1 1/8", 1 1/4"

1/2" drive Deep Sockets: 15/16", 1 1/4"

1/2" drive Ratchet and attachments

1/2" drive Breaker Bar - 24" long

1/2" drive Torque Wrench: 200 ft-lb

Crescent Wrench: 12” [300 mm]

Allen Wrench: 3/8”

Impact Wrench: 1/2"
Important:
Because every impact is different, Trinity Highway makes no
recommendation whether use or reuse of any part of the system is
appropriate or acceptable following an impact. It is the sole responsibility
of the project engineer and/or the local highway authority and its engineers
to make that determination. It is critical that you inspect this product after
assembly is complete to make certain that the instructions provided in this
manual have been strictly followed.
Miscellaneous

Traffic control equipment

Lifting and moving equipment - Minimum 5,000 lb. capacity required

Air Compressor (100 psi) and Generator (5 kW)

Pry bar

Drift pin 300 mm [12”]

Center punch

Tape measure 25’ [7.5 m]

Chalk line

Concrete marking pencil

Nylon bottle brush for cleaning 7/8” drilled holes

Rags, water, and solvent for touch-up

Chain, 3/8” grade 40, 20’ [6 m] with 1/2” [13 mm] hooks

Acetylene torch
Note:
The above list of tools is a general recommendation and should not be considered
an extensive list. Depending on specific site conditions and the complexity of the
assembly specified by the appropriate highway authority, the required tools may vary.
Decisions as to what tools are needed to perform the job are entirely within the discretion
of the specifying highway authority and the authority’s selected contractor performing the
assembly of the system at the authority’s specified assembly site.