Trinity Highway QuadGuard Elite M10, Руководство по сборке изделия

Страница: 41 / 60

TrinityHighway.com 40 Revision C September 2021
16) Checking The System
At this point tighten all Mushroom Bolts and recheck to ensure that all fasteners are properly
tightened throughout the system (anchor bolts, etc.). Check all Fender Panels. If they do not fit
tightly against the underlying panel, system realignment may be necessary (Figure 38).
Bolt Torque Specifications
Warning:
Anchor Studs Torque to 100 ft-lb
Shall Not protrude above nuts
(p. 29, Figure 18)
All Other Bolts Tightened
Fender Panel Maximum gap allowed:
Narrow Systems – 0.78” [20 mm]
Pre-Assembled System Installation Instructions
The QuadGuard Elite M10 may be ordered pre-assembled. Pre- assembled systems
come in two 4-Bay sections.
A forklift or equivalent is required for installation.
A. Remove one Monorail Guide from the same side of each Diaphragm of both pre-
assembled sections.
B. Unbolt the rear Cylinder and rear Fender Panels from the Backup.
C. Lift each 4-Bay section away from the Backup and Monorails.
D. Place the Backup and Monorails into position and install anchors (pp. 27-29).
E. Lift the rear section onto the Monorail and against the Backup.
F. Reconnect rear Cylinder and Fender Panels to Backup (p. 35).
G. Lift the front section onto the Monorail and push it back until it contacts the front Diaphragm
of the rear section.
H. Reattach ME3/ME2 Cylinders, mushroom washers, and monorail guide assemblies at
each diaphragm.
Figure 38
Fender Panel Gap
MAXIMUM GAP = .78” [20 mm]
FENDER PANEL
UNDERLYING FENDER,
TRANSITION, EXTENSION
OR SIDE PANEL
TRAFFIC