Trillium 10-WSP, Инструкция по установке, эксплуатации и обслуживанию, Страница: 25 / 72

WSP™
DATA SHEET WSP™ SELF-PRIMER PUMPS WSP-D300_10
Rev. 3 01/09/20
© 2019 The Factory
25
IT IS RECOMMENDED THAT THE BEARING BE CLEANED AND INSPECTED IN PLACE
TO PREVENT DAMAGE DURING REMOVAL FROM THE SHAFT. WE HIGHLY
RECOMMEND REPLACEMENT OF THE BEARINGS ANYTIME THE SHAFT AND
BEARINGS ARE REMOVED.
BEFORE USING ANY CLEANING SOLVENTS CAREFULLY READ AND FOLLOW ALL
PRECAUTIONS PRINTED ON THE SOLVENT CONTAINER. CLEANING SOLVENTS ARE
KNOWN TO BE TOXIC AND FLAMMABLE AND ARE ONLY TO BE USED IN WELL-
VENTILATED AREAS AWAY FROM EXCESSIVE HEAT, SPARKS, AND FLAMES.
Use fresh cleaning solvent, thoroughly clean bearings. To dry them, use compress,
filtered air then lubricate with light oil.
BEARINGS MUST BE KEPT IN AN ENVIRONMENT THAT IS FREE OF ALL DIRT AND
FOREIGN MATERIAL. FAILURE TO DO SO WILL RESULT IN A SHORTER BEARING
LIFE. THE BEARINGS SHOULD NEVER BE SPUN DRY AS THIS MAY SCRATCH THE
BALLS OR RACES AND WILL CAUSE PREMATURE BEARING FAILURE.
To check for roughness or bearing binding, rotate bearings by hand and inspect the
balls. If the bearing balls are discolored or rotating them is rough, replace the
bearings.
Bearing tolerances provide tight fit of the bearings onto the pump shaft as well as a
snug fit in the bearing housing. The bearing housing, the bearings or the shaft
should be replaced if adequate bearing fit is not maintained.
If the bearings need to be replaced, take off the outboard bearing snap ring, and
press the bearings from the shaft or use a bearing puller instead.
G. DISASSEMBLY OF THE TWO-PIECE BEARING HOUSING
NOTE:
The two-piece bearing housing comes assembled from the factory and
should not require disassembly. If disassembly is necessary, the following
applies.