Toro Reelmaster 2000-D, Руководство по обслуживанию

Страница: 188 / 208

Reelmaster 2000–D Page 7 – 16 Cutting Units
Cutting Reel
1. Hydraulic motor
2. Cap screw
3. O–ring
4. Cap
screw
5. Lock washer
6. Side plate (RH)
7. Roll
pin
8. Lock nut
9. Washer head screw
10. Frame assembly
11. Front grass guard
12. Rear grass guard
13. Cutting reel
14. Flange nut
15. Side plate (LH)
16. Washer
17. Spacer
18. Link
19. Bushing
20. Cap screw
21. Cap screw
22. Cap screw
23. Shipping plug
24. Reel coupler (LH) 25. Grease fitting
26. Flange head screw
27. Bearing housing
28. Bearing
29. Reel coupler (RH)
30. Spider coupler
31. Rubber side cover
32. Rubber center cover
33. Rivet
34. Cover gasket
35. Cover
36. Seal guard (8 & 11 blade reels)
Figure 14
34
3
23
35
13
2
4
5
6
7
8
9
16
17
18
19
20
21
22
24
25
26
27 28
29
30
11
10
12
14
15
2
5
2
31
31
32
33
8
16
26
27
28
1
FRONT
RIGHT
55 to 65 ft–lb
(75 to 88 N–m)
55 to 65 ft–lb
(75 to 88 N–m)
THREAD–LOCKING COMPOUND
THREAD–LOCKING COMPOUND
ANTI–SEIZE LUBRICANT
36
36
Remove Cutting Reel (Fig. 14)
1. Remove hydraulic motor from the cutting unit (see
Hydraulic Reel Motor Removal). Remove cover and
gasket from the opposite end of the cutting unit.
2. Remove cutting unit from the machine (see Traction
Unit Operator’s Manual).
3. Remove bedbar assembly from the cutting unit (see
Bedbar Removal).
4. Remove front roller from the cutting unit (see Roller
Removal).
NOTE: A 3/8–inch drive ratchet with an extension will
fit into the square hole of the reel coupler.
5. Unscrew reel coupler (LH) from the reel. This cou-
pler has left hand threads. Unscrew reel coupler (RH)
from the reel. This coupler has right hand threads.
IMPORTANT: Support reel to prevent it from dropping
when the bearing housings are removed.
6. Remove flange head screws from both bearing
housings. Pull bearing housings and bearings from reel.
Remove reel from the cutting unit.
7. Rotate bearings within the bearing housings and re-
move bearings from both bearing housings through the
loading grooves.