Toro Reelmaster 2000-D, Руководство по обслуживанию

Страница: 190 / 208

Prepare Reel for Grinding
NOTE: Check to make sure reel bearings are in good
condition and properly adjusted before grinding reel.
1. Remove bedbar assembly (see Bedbar Removal
and Installation).
2. Remove front roller and brackets (see Roller Remov-
al and Installation).
NOTE: Most reel grinders require that the rear roller as-
sembly be mounted to the cutting unit for proper support
in the reel grinder. The rear roller must be parallel to the
reel shaft to remove taper when grinding, or the cutting
unit must be aligned so the grinding wheel will travel par-
allel to the reel shaft. This will result in the the reel being
ground to the desired cylinder shape.
NOTE: When grinding, be careful to not overheat the
reel blades. Remove small amounts of material with
each pass of the grinder.
3. After completing grinding process:
A. Install front roller and brackets (see Roller Re-
moval and Installation).
B. Install bedbar assembly (see Bedbar Removal
and Installation).
C. Complete cutting unit set–up and adjustment se-
quence (see Cutting Unit Operator’s Manual).
Reel Grinding Specifications
Nominal Reel Diameter 7 inches (178 mm)
Service Limit
Reel Diameter 6.2 inches (158 mm)
Blade Relief Angle 30
o
Relief Angle Range 20
o
to 40
o
Blade Land Width 0.060 inch (1.5 mm)
Land Width Range 0.050 to 0.090 inch (1.3 to 2.3 mm)
Maximum Reel Taper 0.060 inch (1.5 mm)
1
– D
2
D
1
D
2
BLADE RELIEF ANGLE
REEL DIAMETER
BLADE
LAND
WIDTH
REEL DIAMETER TAPER = D
Figure 15
Cutting Units Page 7 – 18 Reelmaster 2000–D