Toro Reelmaster 2000-D, Руководство по обслуживанию

Страница: 186 / 208

Roller Service
1
2
3
4
5
10
11
12
7
8
9
4
4
5
6
2
6
7
8
4
5
6
7
8
See assembly process for
tightening procedure
Figure 13
1. Full roller 5. Bearing cone (outer) 9. Wiehle roller
2. Roller shaft 6. Outer seal 10. Sectional roller shaft
3. Grease seal 7. Adjustment nut 11. Bearing cone (inner)
4. Bearing cup 8. Grease fitting 12. Sectional roller
Disassembly
1. Clean inside of roller around both adjustment nuts
and roller shaft ends. Both areas should be free of dirt
and debris.
2. Remove adjustment nut from one end of the roller
shaft. On the sectional roller, remove adjustment nuts
from each end of the roller.
3. Keep roller level and slide the shaft with the remain-
ing adjustment nut out of the roller. On the sectional roll-
er, slide both sectional rollers off the shaft.
4. Secure roller in a vise.
5. Remove outer seals.
6. Remove both bearing cones. On the sectional roller,
remove all four bearing cones.
NOTE: An electric arc welder can be used to shrink the
bearing cup to simplify its removal. Only a small arc in
one location on the cup is required.
7. Remove both bearing cups from the roller. On the full
roller, remove both inner seals. On the sectional roller,
remove all four bearing cups.
8. Discard seals and bearings that were removed from
roller.
Cutting Units Page 7 – 14 Reelmaster 2000–D