Toro Reelmaster 2000-D, Руководство по обслуживанию

Страница: 182 / 208

Reelmaster 2000–D Page 7 – 10 Cutting Units
Bedbar
1. Rubber bushing
2. Flanged bushing
3. Jam nut
4. Compression spring
5. Washer
6. Bedbar
fitting
7. Adjuster spacer
8. Spring arm
9. Bedbar adjuster
10. Bedbar pivot
11. Grease fitting
12. Flange bushing
13. Bushing
14. Adjusting lock nut
15. Adjusting nut
16. Adjusting housing
17. Lock nut
18. Carriage bolt
19. Bedbar yoke
20. Bedbar washer
21. Bedbar housing
22. Spacer 23. Flat washer
24. Lock washer
25. Cap screw
26. Bedbar
27. Bedknife
28. Bedknife screw
29. Reel frame
30. Weight (Models 03213 and 03214)
31. Cap screw
32. Lock nut
Figure 8
24
25
26
27
28
1 2 3 4 5
8
9
11
6
12
13
14
15
16
17
18
20
21
22
23
7
10
5
2
1
12
13
18
17
19
29
FRONT
RIGHT
ANTI–SEIZE LUBRICANT
ANTI–SEIZE LUBRICANT
ANTI–SEIZE
LUBRICANT
250 to 300 in–lb
(28 to 34 N–m)
30
31
32
PERMANENT
THREAD–LOCKING
COMPOUND
Removal
1. Turn bedbar adjuster to loosen bedknife to reel con-
tact. Unscrew bedbar adjuster (left–hand threaded)
while loosening jam nut from the compression spring
until the bedbar fitting is clear of the bedbar yoke.
2. Remove capscrew, lock washer, flat washer, and
spacer from the right end of the bedbar.
3. Loosen adjustment nuts on the adjusting housing
(Fig. 9).
4. Remove both carriage bolts and nuts from the ad-
justing housing (Fig. 9).
5. Remove both carriage bolts and nuts from the bed-
bar housing. Remove bedbar from the cutting unit.
6. Remove adjusting housing and bedbar housing from
the bed bar. Remove bedbar washer.
7. If necessary (Models 03213 and 03214), remove cap
screws and lock nuts to allow removal of weights from
bedbar. Cap screws have permanent thread–locking
compound applied and may be difficult to remove.
8. Sharpen or replace bedknife as necessary (see Bed-
knife Replacement and Grinding).