Toro Reelmaster 2000-D, Руководство по обслуживанию

Страница: 181 / 208

Reelmaster 2000–D Page 7 – 9 Cutting Units
Service and Repairs
Hydraulic Reel Motor
Removal (Fig. 7)
1. Remove two cap screws holding the hydraulic motor
to the bearing housing.
2. Remove hydraulic motor, o–ring, and spider coupler
from the bearing housing. Position hydraulic motor
away from the cutting unit prior to removing or working
on the cutting unit.
Inspection
1. Inspect spider coupler for wear. Replace spider cou-
pler if worn.
2. Check reel coupler inside bearing housing. If reel
coupler is loose, remove and check for worn threads.
Replace coupler if threads are worn. Reinstall reel cou-
pler (see Cutting Reel).
Installation (Fig. 7)
NOTE: The cutting unit can be installed with the hy-
draulic motor on either side. If installing on the opposite
side, remove cap screws, cover, and cover gasket; rein-
stall them on the other bearing housing.
1. Dip spider coupler in No. 2 general purpose lithium
base grease. Reinstall spider coupler into the bearing
housing.
2. Install o–ring on the front plate of the motor. Mount
hydraulic motor to the bearing housing. Secure motor
with two cap screws.
3. Grease bearing housing sufficiently to fill housing
with grease (see Cutting Unit Operator’s Manual).
1. Reel motor
2. Cap screw
3. O–ring
4. Spider
coupler
Figure 7
1
3
4
2
Cutting Units