Toro Reelmaster 2000-D, Руководство по обслуживанию

Страница: 96 / 208

57.1 Rev. A
Reelmaster 2000--D Hydraulic System Page 4 --
Cutting Reel Motor Service (Serial Number Above 290000000)
1. Dust seal
2. Retaining ring
3. Flange washer
4. Shaft seal
5. Front flange
6. Pressure seal
7. Back--up gasket
8. Front wear plate
9. Dowel pin
10. Idler gear
11. Drive shaft
12. Rear wear plate
13. O--ring
14. Relief valve
15. Body
16. Washer (4 used)
17. Lock washer (4 used)
18. Cap screw (4 used)
Figure 44.1
2
3
6
9
9
10
11
13
1
5
7
12
14
15
16
17
18
4
6
7
8
14
33 ft--lb
(45 N--m)
Disassembly (Fig. 44.1)
1. Plug motor ports and clean the outside of the motor
thoroughly. After cleaning, remove plugs and drain any
oil out of the motor.
2. Use a marker to make a diagonal line across the
front flange and body for assembly purposes (Fig. 44.2).
IMPORTANT: Prevent damage when clamping the
reel motor into a vise; clamp on the front flange only.
Also, use a vise with soft jaws.
3. Clamp front flange of motor in a vise with soft jaws
with the shaft end down. Figure 44.2
MARKER LINE