Toro Reelmaster 2000-D, Руководство по обслуживанию

Страница: 8 / 208

Jacking Instructions
CAUTION
er
jack stands, the machine may move or fall,
When changing attachments, tires, or perform-
ing other service, use correct blocks, hoists,
and jacks. Make sure machine is parked on a
solid level surface such as a concrete floor.
Prior to raising machine, remove any attach-
ments that may interfere with the safe and prop-
raising of the machine. Always chock or
block wheels. Use jack stands or solid wood
blocks to support the raised machine. If the ma-
chine is not properly supported by blocks or
which may result in personal injury.
Jacking the Front End
1. Set parking brake and chock rear tire to prevent the
machine from moving.
2. Position jack securely under the frame, just to the in-
side of the front tire.
3. Jack front of machine off the ground.
4. Position jack stands or hardwood blocks under the
frame as close to the wheel as possible to support the
machine.
Safety and Instruction Decals
Numerous safety and instruction decals are affixed to
the traction unit and the cutting units of the Reelmaster
2000–D. If any decal becomes illegible or damaged, in-
Jacking the Rear End
1. Set parking brake and chock both front tires to pre-
vent the machine from moving.
2. Place jack securely under the frame directly in front
of the castor fork/rear wheel.
3. Jack rear of machine off the ground.
4. Position jack stands or hardwood blocks under the
frame to support the machine.
stall a new decal. Part numbers are listed in your Parts
Catalog. Order replacement decals from your Autho-
rized Toro Distributor.
Safety
Page 1 – 4
Reelmaster 2000–D