Toro Dingo TX 525, Руководство по обслуживанию

Страница: 358 / 554

HYDRAULIC SYSTEM
6-95 TX525 Service Manual Rev. 000
6. Continue to rotate the head counter-clockwise until
the retaining ring is completely removed (Fig. 1194).
8. Remove the barrel from the vise.
INSPECT ROD: There should be no scratches or pits
deep enough to catch the fingernail. Pits that go to
the base metal are unacceptable. Scratches that
catch the fingernail but are not to the base metal,
less than 0.5” long (1.27cm) and primarily in the
circumferential direction are acceptable provided
they cannot cut the rod seal. Chrome should be
present over the entire surface of the rod and the
lack thereof is unacceptable. In the event that an
unacceptable condition occurs, the cylinder should
be replaced.
INSPECT HEAD: Visually inspect the inside bore
for scratches or polishing. Deep scratches are
unacceptable. Polishing indicates uneven loading
and when this occurs, the bore should be checked
for out of-roundness. If out-of-roundness exceeds
0.007” (.18mm), this is unacceptable. Check the
condition of the dynamic seals, looking particularly
for metallic particles embedded in the piston seal
surface. Remove the seals. Damage to the seal
grooves, particularly on the sealing surfaces, is
unacceptable. In the event that an unacceptable
condition occurs, the cylinder should be replaced.
Fig 1194 PICT-3037
7. Pull out on the rod to remove the piston and head
assembly from the barrel (Fig. 1195).
Fig 1195 PICT-3038a