TMC TMC 1000E, Руководство по эксплуатации

Страница: 83 / 182

Injection Molding Machine Chapter 4
V3.0
4-40
safety door.
Ｈ
F4 AUTO TONNAGE
：
Press F4
，
automatic mold clamping force adjustment process will
start
，
it takes about one minute before finishing
，
alarm will be activated upon completion.
Ｉ
DIE HEIGHT JOG
：
When set on
，
manual die height adjusting operation is running in fine
mode
，
when push mold thick or mold thin key on the panel
，
die height adjustment
gear will only rotate one tooth.
Ｊ
MOLD SETUP MODE: when both DIE HEIGHT ADJ. and MOLD SETUP MODE are set
on
，
clamp close
，
clamp open and ejector advance are controlled by internal P/V setting
that is low pressure and low speed. This mode is used for mould setup. When machine
power is restarted or operation mode is switched from manual to semi-auto or full-auto
mode
，
MOLD SETUP MODE and DIE HEIGHT ADJ. function will be reset to off.
NOTES ON MOLD SETUP MODE in USA model
USA machines ranging from 60E to 250E
，
top guard with limit switch is fitted over mould
area
，
mould setup mode is activated by following conditions.
1 When fitting mold
，
if rear operator gate is opened
，
pump will be shut off and alarm be fired
，
by opening front operator gate can disable buzzer sound temporarily but alarm condition
still exists.
2 With both front operator gate and rear operator are closed and
DIE HEIGHT ADJ. function
is on
，
opening top guard will not shut off pump
，
this condition is taken as MODE SETUP
MODE
，
in this mode
，
clamp close and ejector advance will be forced to run in low
speed/pressure only
，
regardless of what clamp/ejector settings.
3 For safety reason
，
in mold setup mode
，
if pump is off by pushing pump key by purpose
，
top
guard must be closed again in order to re-start pump.
4 If top guard is opened while DIE HEIGHT ADJ. function is off
，
pump will be shut off and
alarm be fired.