TMC TMC 1000E, Руководство по эксплуатации

Страница: 115 / 182

Injection Molding Machine Chapter 5
V3.0
5-10
Content of Alarm Cause of Alarm Release of Alarm
17.
Safety door front be
open
Please check front
safety door & input
no. 101
M / S / A: I/O 101 OFF Close operation safety gate
18.
Safety door rear be
open
Please check rear
safety door & input
no. 103
M / S / A : I/O 103 OFF Close rear safety gate
21.
Thermocouple
abnormal
Please check
temperature
page(opn/inv)check
couple open/inverse M / S / A : Thermocouple
disconnected.
1.
Check heater band
，
wire
，
fuse
，
SSR
，
thermocouple
24.
Mold open time over
Please check clamp
setting
S / A : T/C 325 clamp open
monitor time over
1.
Open safety gate
2.
Adjust T/C 325 set value
3.
Check clamp open/close
mechanism and hydraulic
circuit.
25.
Core in/out position
abnormal
Please check core
position & setting
M
：
manual corepull
performed not in core-in
core-out position
S / A : during corepull
operation
，
T/C 321-full
cycle time over
M / S / A : eject operation
performed not in
corepull out ending
position.
1.
Open safety gate
2.
M : move clamp open/close
to corepull position
，
then
perform corepull.
3.
S / A : adjust T/C 325 set
value
4. C
heck corepull device.
27.
Lot parts count over S / A : T/C 445-lot quantity
counting exceeded
1.
Open safety gate
2.
Upon completion of T/C
444 lot quantity
，
alarm
time will be cleared
automatically