TMC TMC 1000E, Руководство по эксплуатации

Страница: 116 / 182

Injection Molding Machine Chapter 5
V3.0
5-11
Content of Alarm Cause of Alarm Release of Alarm
28.
Total parts count over
Please check part shot
count & setting S / A : Product counting
exceeded
1.
Open safety gate
2.
Reset product counter
29.
Control panel temp.
too HI./LOW
Please check control
panel. Temperature &
cooling it down less 50
℃
M / S / A : temperature inside
control box exceeds
65 degree or in
negative
temperature
1. O
pen safety gate
2. I
mprove temperature
condition inside control box
3. TP board +20
，
C wire
breaking
30.
Mould dose not open
end (not end)
Please open the mould
at open end position M : clamp open/close position
is not at end position
before barrel cleaning
1. O
pen safety door
2.
Clamp must be open before
cleaning barrel
3
1. Purge cover be open
Please check purge
cover & input no. 210
M / S / A : I/O 210 OFF
1.
Open safety gate
2.
Close nozzle cover
3. Check limit switch
32. Parts
not pass
(confirmation)
Please check parts &
input no.122
S / A : When T/C 326 starts
time counting I/O 122
OFF
1.
Open safety gate
2.
Check product pick-out
device
33. Heater t
emperature
ready
Please open the door
and close to reset
alarm
M: Temperature reaches to
set value and T/C 42-
cold material start
protection time
completed.
1.
Open safety gate
34. Function not selected
Please check this
function is it enable!
M : function selection not
performed before
operation of manual
button
1.
Open safety gate
2. Select this function