Tieline Bridge-IT, Руководство пользователя

Страница: 168 / 227

168 Bridge-IT Manual v4.0
© Tieline Research Pty. Ltd. 2019
SmartStream PLUS redundant streaming, you can use two IP interfaces at the studio for
additional redundancy.
Prerequisites
Version 2.16.xx firmware is required to use Fuse-IP. Before configuring Fuse-IP you need:
·
The IP address (or addresses) for the codec acting as the server at the studio.
·
The serial number of the server codec to which you are connecting using Fuse-IP.
Configuring a Fuse-IP Server at the Studio
1. Press the SETTINGS button.
2. Use the down navigation button to select Fuse-IP and press the button.
Important Note:
Ensure Fuse-IP is disabled prior to configuration. Navigate to Settings
> Fuse-IP > Status and press the button to disable Fuse-IP if it is enabled.
3. Navigate down to Fuse-IP Mode and press the button to select Server if the codec is at
the studio and not initiating the connection. Note: the server codec serial number will be
displayed and needs to be entered into the Fuse-IP client codec.
4. Leave the default Fuse-IP Port as 8999 in most situations unless this port is already in
use, e.g. you have multiple codecs behind a firewall using Fuse-IP, therefore you need to
allocate a different port for each Fuse-IP tunnel. Note: the port number on the client and
server codecs must be the same.
5. The codec is now configured to connect with a client codec over a Fuse-IP tunnel.
Navigate up to Status and then press the button to create a Fuse-IP tunnel between
the server and client codecs.
Configuring a Fuse-IP Remote Client
1. Press the SETTINGS button.
2. Select Fuse-IP and press the button.