Tieline Bridge-IT, Руководство пользователя

Страница: 108 / 227

108 Bridge-IT Manual v4.0
© Tieline Research Pty. Ltd. 2019
6. Follow the instructions on the right-hand side of the panel to configure the transport settings for
the connection, then click Next . Note: select UDP/IP +RTP for RFC compliant streaming. If
auxiliary data is enabled the audio stream will not be RFC-compliant.
Important Notes:
·
The encode and decode direction is configured automatically for Encode Only (server
program) or Decode Only (client program). This setting is configured when you select
either Multicast Server or Multicast Client when you first create the program in the
wizard.
· Use firmware higher than 2.8.xx in the Bridge-IT, Genie and Merlin families of codecs to
enable auxiliary data.
7. Configure the multicast IP address and audio port (the same multicast address and port must
be used for both the server and client programs), then specify which IP streaming interface is
used to dial this connection, e.g.
Primary ( LAN / ETHERNET port and default setting) or VLAN
if configured. Note: By default Any will select Primary .
8. Click the drop-down arrows on the right-hand side of each text box to select the Encoding
,
Sample rate
,
Bit rate or Sample size options. Click Next to continue.
9. Click to configure:
·
Auto Jitter Adapt and the preferred auto jitter setting using the drop-down arrow for Buffer
priority . It is also possible to configure the Minimum depth and Maximum depth of jitter
over the connection. See Configuring the Jitter Buffer for more details.
·
Alternatively, select a Fixed Buffer Level and enter the Jitter Depth , which must be
between 12ms and 5000ms depending on the algorithm you select.