Tieline Bridge-IT, Руководство пользователя

Страница: 114 / 227

114 Bridge-IT Manual v4.0
© Tieline Research Pty. Ltd. 2019
5. This audio stream connection in the wizard will allow the codec to dial. Enter the name of the
connection in the text box, then click Next .
6. Follow the instructions on the right-hand side of the panel to configure the transport settings for
the connection, then click Next . Note: select UDP/IP +RTP for RFC-compliant streaming. If
auxiliary data is enabled the audio stream will not be RFC-compliant.
Important Notes:
· The encode and decode direction is configured automatically for Encode Only (server
program) or Decode Only (client program). This setting is configured when you select
either Multicast Server or Multicast Client when you first create the program in the
wizard.
·
The TTL value you need to use is dependent upon your network infrastructure. Please
consult your network administrator if you are unsure about how to configure this setting.
·
Use firmware higher than 2.8.xx in the Bridge-IT, Genie and Merlin families of codecs to
enable auxiliary data.
7. Configure the multicast IP address and Remote Audio Port (the same multicast address and
port must be used for both the server and client programs), then specify which IP streaming
interface is used to dial this connection, e.g.
Primary ( LAN / ETHERNET port and default
setting) or VLAN if configured. Note: By default Any will select Primary .