Tieline Bridge-IT XTRA, Руководство пользователя

Страница: 97 / 209

97
© Tieline Pty. Ltd. 2015
Bridge-IT XTRA Manual
5. Follow the instructions on the right-hand side of the panel to configure the transport settings
for the connection: Ensure that you select SIP as the Session Protocol menu. Then click
Next .
6. Configure the destination codec Address and Audio Port , then the network interface used to
dial the connection, e.g. Primary ( LAN / ETHERNET port and default setting) or VLAN if
configured. Note: By default Any will select Primary .
At this point you can click Save Program and save the program with the default jitter and FEC
settings in the codec. Alternatively, click Next to specify individual algorithm, jitter buffer and
FEC settings for this connection and configure backup audio for this audio stream
(recommended).
Important Notes:
· If your codec is registered with same SIP registrar as the destination codec then you
only need to enter the SIP user name to dial successfully.
· The default UDP audio port when using SIP is 5004 in Tieline codecs. To contact a codec
that is behind a firewall or NAT-enabled router, it is essential that this and all other
relevant ports are open and forwarded to the other device.
7. Click the drop-down arrows on the right-hand side of each active drop-down menu to adjust
the Encoding, Sample rate or Bit rate parameters. Click Next to continue.