Tieline Bridge-IT XTRA, Руководство пользователя, Страница: 111 / 209

111
© Tieline Pty. Ltd. 2015
Bridge-IT XTRA Manual
this manual, or see Reset Factory Default Settings to clear recent log history using the web-GUI.
16.17 RS232 Data Configuration
The codec supports both in-band and out-of-band data depending on the algorithm you are using.
RPTP data is automatically enabled when using the Tieline Music or MusicPLUS algorithms over
IP. It is also possible to enable synchronized out-of-band data using any algorithm.
Algorithm Selected IP
Tieline Music and MusicPLUS
·
In-band RPTP data enabled automatically
·
Synchronized out-of-band data can be enabled and
disabled
All other algorithms
·
Synchronized out-of-band data can be enabled and
disabled
The codec can be connected to external devices and send RS232-compatible data via the serial
port on the rear panel of the codec. To enable RS232 data within a connection, select
Enable
Auxiliary Data when creating a program in the Programs panel wizard. Alternatively, select using
the codec Setup menu (see Bridge-IT XTRA Relays and RS232 Data ).
Setting RS232 Data Rates and Flow Control
1. Open the web-GUI and click the Settings symbol at the top of the screen to display the
Settings panel .
2. Click the Options button.
3. Click the Baud rate drop-down menu arrow to select the serial port baud rate which matches the
baud rate of the external device connected to the RS232 port on the codec.
4. Click to select the Enable flow control check box and enable flow control, then click Save
settings .
Important Notes:
· When connecting to G3 codecs over IP only in-band data is available via the Music and
MusicPLUS algorithms.
·
Use firmware higher than 2.8.xx in the Bridge-IT, Genie and Merlin families of codecs to
enable auxiliary data over multicast connections.
·
It is important to enable serial port flow control as it regulates the flow of data through the
serial port. If disabled, data will flow unregulated and some may be lost.
· Ensure you configure the serial port baud rate to match the setting of the external device
to which you are connecting. Ideally the settings on both codecs should match, or you
could have data overflow issues.
· Only the dialing codec needs to be configured to send RS232 data. Session data sent
from the dialing codec will configure all other compatible codecs (non-G3) when you
connect.