Tieline Bridge-IT XTRA, Руководство пользователя

Страница: 159 / 209

159
© Tieline Pty. Ltd. 2015
Bridge-IT XTRA Manual
1. Press the SETTINGS button.
2. Select LAN and press the button.
3. Use the down navigation button to select ETH1 or a VLAN interface.
4. Select Usage and choose the appropriate control and/or streaming mode for the connection,
then press the button.
5. Select IPv4 and press the button.
6. Select DHCP and press the button.
7. Use the up navigation button to scroll to the top of the menu and select Apply Setting ,
then press the button to confirm the new settings.
Configure a Static IPv4 Address
Static IP addresses are fixed addresses which are recommended for studio installations. Using a
static IP address ensures remote codecs can connect reliably using the same IP address over time.
1. Press the SETTINGS button.
2. Select LAN and press the button.
3. Use the down navigation button to select ETH1 or a VLAN interface.
4. Select Usage and choose the appropriate control and/or streaming mode for the connection,
then press the button.
5. Select IPv4 and press the button.
6. Select Static and press the button.
7. Navigate to v4 Static and enter the IP address, then press the button.
8. Navigate to v4 Snet and enter the Subnet Mask, then press the button.
9. Navigate to v4 Gway and enter the Gateway details, then press the button.
10.Use the up navigation button to scroll to the top of the menu and select Apply Setting ,
then press the button to confirm the new settings.
11.Check the Unit Details menu to ensure the new static IP address has been entered
correctly.
IPv6 Address Assignment
There are three IPv6 settings available for the Ethernet port and any VLANs which are configured.
1. Auto: An address is automatically assigned to the codec when you connect the codec to an
IPv6 router. This process is similar to how an IPv4 DHCP address is assigned.
2. Manual: Select to manually enter IPv6 address details.
3. Off: Select to ignore IPv6 address details.
Important Note: Select Off if you are not using IPv6 to connect to another device. This
ensures your codec will attempt to connect using IPv4 at all times.
To adjust this setting:
1. Press the SETTINGS button.
2. Select LAN and press the button.
3. Use the down navigation button to select ETH1 or a VLAN interface.