Thinkvert TI10 Series, Руководство пользователя

Страница: 4 / 70

User Manual of TI10 Series Variable Frequency Drive

All our products have been subjected to withstand voltage test before leaving
the factory. It is forbidden to conduct this test on the Variable Frequency Drive;
otherwise there is a risk of equipment damage!

Terminal signal lines of the Variable Frequency Drive shall be far away from main
power line, and they be vertically crossed under the condition that the distance cannot
be guaranteed, otherwise the control signals shall be interfered!

When the length of motor cable is more than 100m, it is recommended to select
output reactor, otherwise there is a risk of equipment failure!
■
Operation
Danger

If the storage time of the Variable Frequency Drive exceeds 2 years, the voltage
regulator shall be applied to boost the voltage gradually; otherwise there is a risk of
equipment damage!

After the wiring is finished according to the requirements of section 1.3, the
Variable Frequency Drive can only be powered on; otherwise there is a risk of
equipment damage or electric shock!

After the Variable Frequency Drive wiring is confirmed to be correct, the power
can only be turned on after the cover plate is covered. It is forbidden to open the
cover plate after the power is turned on; otherwise there is a risk of electric shock!

After the Variable Frequency Drive is powered on, do not touch the Variable
Frequency Drive and its peripheral circuits regardless of the state of the Variable
Frequency Drive, otherwise there is a risk of electric shock!

Before running the Variable Frequency Drive, it must check there is no person in
surrounding area who can reach the motor so as to prevent personal injury.

During the operation of the Variable Frequency Drive, foreign matters shall be
avoided from falling into the equipment; otherwise there is a risk of equipment
damage!

Non-professional technicians are forbidden to test signals during operation,
otherwise there is a risk of personal injury or equipment damage!

Do not change Variable Frequency Drive parameters at will; otherwise there is a
risk of equipment damage!
Note

Please confirm whether the number of phases and rated voltage of the power
supply are consistent with the nameplate of the product, otherwise equipment
damage may be caused!

Check whether there is short circuit in the peripheral circuit connected to the
Variable Frequency Drive and whether the wiring is tight, otherwise the equipment
damage may be caused!

Before operation, please make sure that the motor and machinery are within the
allowable range of use, otherwise the equipment may be damaged!