Thinkvert TI10 Series, Руководство пользователя

Страница: 3 / 70

User Manual of TI10 Series Variable Frequency Drive
explosive gas, otherwise there is a risk of explosion!

Do not twist the fixing bolts of equipment components at will, especially the
bolts marked with red, otherwise there is a risk of equipment damage!
Note

It shall be handled gently, and the bottom plate of the product is held to prevent
foot injury or Variable Frequency Drive damage!

Please install it in a place that can bear the weight of the Variable Frequency
Drive, otherwise there is risk of equipment damage and personal injury when falling!

Avoid dropping drilling residues, thread ends and screws into the Variable
Frequency Drive during installation; otherwise it may cause failure of Variable
Frequency Drive.

When the Variable Frequency Drive is installed in the cabinet, heat dissipation
shall be properly handled; otherwise it may cause product failure or damage!
■
Wirin
g
Danger

Wiring must be carried out by qualified personnel; otherwise there is a risk of
electric shock or equipment damage!

Strictly follow this manual during wiring; otherwise there is a risk of electric shock
or equipment damage!

Only when the input power supply is completely disconnected can wiring be
carried out, otherwise there is a risk of electric shock!

All wiring and circuits shall meet the requirements of EMC and safety standards.
Please refer to the recommendations in this manual for wire diameter, otherwise
accidents may occur!

The leakage current of the whole Variable Frequency Drive may be more than
3.5mA. In order to ensure safety, the Variable Frequency Drive and the motor must be
grounded; otherwise there is a risk of electric shock!

It must be wired in strict accordance with the screen printing of Variable
Frequency Drive terminals, it is forbidden to connect the three-phase power supply to
the output terminals U, V and W, otherwise there is a risk of equipment damage!

Please install the brake resistor at B1 and B2/+ ends correctly, and do not
connect to other terminals, otherwise there is a risk of equipment damage!

Main circuit terminal wiring screw bolts must be tightened; otherwise there is a
risk of equipment damage!

It is forbidden to connect AC 220V voltage grade signals to terminals other than
control terminals RA, RB and RC; otherwise there is a risk of equipment damage!
Note