Textron Jacobsen Ransomes Parkway 3 Meteor LGNN344, Руководство по безопасности, эксплуатации и техническому обслуживанию

Страница: 63 / 236

en-63
OPERATION 7
7.6 OPERATION OF THE MACHINE __________________________________________
Read the Safety Instructions.
BEFORE OPERATING FOR THE FIRST TIME
• Check and adjust tyre pressure, if necessary, see section 4.2 Specification.
• Add diesel fuel to tank if necessary.
• Check engine oil and top-up, if necessary.
• Check radiator coolant and top-up, if necessary (50% antifreeze solution).
• Make sure you understand the information contained in the previous sections.
7.7 STARTING THE ENGINE _______________________________________________
The following procedure is for starting cold engines.
1. Ensure the FWD/REV pedal is in the neutral position, the mow switch is off, the throttle setting is in a
mid position.
2. Turn the ignition switch fully clockwise and hold until the engine starts (approximately 5-10 sec.)
3. The glow plugs are auto timed depending on the coolant temperature for operating the starter motor
(This should only take a few seconds)
4. When the engine starts, release the key immediately and it will return to the RUN position.
5. If the engine does not start, return key to the OFF position and try again.
NOTES:
•
If the engine fails to start after two attempts, wait 20 seconds and try again.
• The starter motor must not be run continuously for longer than 30 seconds or it may fail.
• If the red LED’s on the display flash whilst starting one of the safety interlock switches has not been set
correctly.